A finished-part length and a supplied titanium blank length are separate requirements. State the supplied length limits, end condition and intended machining allowance together so that an acceptable blank can still produce the finished component.
Keep three dimensions separate
| Term | Meaning | Order clarification |
|---|---|---|
| Finished length | Drawing requirement after the planned operations | Final dimension and tolerance |
| Supplied blank length | Accepted dimension at receipt | Nominal length and upper/lower limits |
| Machining allowance | Stock deliberately retained for later removal | Amount and allocation by end |
Check the shortest acceptable blank
Use the lower supplied-length limit when checking whether the blank can clean up. Compare it with the greatest permitted finished length plus the material needed for the planned end operations. This is a stock-planning check, not a substitute for the drawing or a supplier capability study.
Saw kerf is material lost during cutting. It belongs in the parent-stock yield calculation and should not be confused with the stock remaining on each delivered blank. Avoid adding the same allowance twice.
Worked example: check the lower limit
This hypothetical example illustrates the arithmetic only; the allowances and tolerances are not SAKY ALLOY supply capabilities or standard limits. Suppose a finished part is 100.00 ±0.10 mm long and the process planner requires 0.80 mm of facing stock at each end. The required minimum blank length is 100.10 + 0.80 + 0.80 = 101.70 mm.
A quotation for 102.00 ±0.50 mm permits a 101.50 mm blank, which is too short for those assumptions. A different agreed length range could satisfy the envelope, but end squareness, workholding and actual cleanup must still be checked. Increasing nominal length without checking its lower limit does not resolve the issue.
Length alone does not define the cut ends
Specify any end squareness, burr, chamfer or face-finish requirement that affects locating, clamping or facing. A length result does not by itself demonstrate that both faces meet these requirements. Agree the measurement basis when irregular cut faces could change the result.
Do not apply a tolerance copied from another manufacturer’s billet specification to every titanium bar. Product form, size, delivery condition, governing standard and supplementary agreement control the actual requirement.
Describe the delivered condition clearly
Identify whether the quotation is for stock lengths, saw-cut blanks or finished machined parts. Record how the pieces retain heat or lot identity after cutting. If the purchaser will machine the ends, distinguish receipt acceptance from the subsequent finished-part inspection.
For precision feeding and diameter requirements, use the separate precision-ground bar guide. This length discussion does not replace its diameter and straightness requirements.
Confirm the product form and inspection requirements for your order.
View Titanium Bar Contact SAKY ALLOY
